首页 | 期刊简介 | 编委会 | 投稿指南 | 常用下载 | 联系我们 | 期刊订阅 | In English
引用本文:郑学斌,张清科,乐韵,蒋宏雷,金珊,王建平,竺俊全.香鱼(Plecoglossus altivelis)精子的超微结构及其与鲤形目及鲑形目其他鱼类精子结构的比较研究.海洋与湖沼,2018,49(4):866-872.
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  下载PDF阅读器  关闭
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 1660次   下载 1107 本文二维码信息
码上扫一扫!
分享到: 微信 更多
香鱼(Plecoglossus altivelis)精子的超微结构及其与鲤形目及鲑形目其他鱼类精子结构的比较研究
郑学斌1, 张清科1, 乐韵2, 蒋宏雷3, 金珊1, 王建平3, 竺俊全1
1.宁波大学 教育部应用海洋生物技术重点实验室 宁波 315211;2.宁波市海洋与渔业执法支队 宁波 315020;3.宁波市海洋与渔业研究院 宁波 315012
摘要:
为了解香鱼(Plecoglossus altivelis)精子的形态结构特点,采用扫描和透射电镜技术观察了香鱼精子的超微结构,并与鲤形目及鲑形目其他鱼类精子结构进行了比较。结果表明,香鱼精子由头部、中段和尾部组成,全长约23.5µ;m。头部呈弹头形,由细胞核外包质膜构成,长约1.8µ;m、宽约0.8µ;m;细胞核从后端中央向前深凹至核的近前端,形成植入窝,使核呈倒U字形,核的前端无顶体;植入窝内有中心粒复合体及小段起始的鞭毛,中心粒复合体由近端中心粒和远端中心粒(基体)组成,两者之间夹角约135º;。中段为“半袖套”结构,长约0.5µ;m,其内部为一较大的“半套筒”形线粒体。鞭毛起始于远端中心粒,由轴丝及外包轴丝的质膜组成,轴丝为典型的“9+2”微管结构;鞭毛两侧有质膜向外突起形成侧鳍。研究显示,香鱼精子与典型的鲤形目(Cypriniformes)鱼类精子卵圆形或圆球形头部及细胞核、不对称的袖套及尾部鞭毛无侧鳍等结构特征不同,也与鲑形目(Salmoniformes)鱼类精子卵圆形或椭圆形头部及马蹄形或浅U形细胞核、两中心粒相互平行或垂直、袖套结构完整等结构特征不同。香鱼精子结构具有种的特异性。
关键词:  香鱼  精子  超微结构  鲤形目  鲑形目
DOI:10.11693/hyhz20180100025
分类号:Q954;S917
基金项目:浙江省科技计划项目,2016C32062号。
附件
SCANNING AND TRANSMISSION ELECTRON MICROSCOPIC OBSERVATION OF SPERMATOZOON IN PLECOGLOSSUS ALTIVELIS
ZHENG Xue-Bin1, ZHANG Qing-Ke1, YUE Yun2, JIANG Hong-Lei3, JIN Shan1, WANG Jian-Ping3, ZHU Jun-Quan1
1.Key Laboratory of Applied Marine Biotechnology, Ministry of Education, Ningbo University, Ningbo 315211, China;2.Ningbo Enforcing Detachment of Oceanology and Fisheries, Ningbo 315020, China;3.Ningbo Academy of Oceanology and Fisheries, Ningbo 315012, China
Abstract:
In order to study the morphological and structural characteristics of spermatozoon in Plecoglossus altivelis, scanning and transmission electron microscopic observation were performed. The observation shows that the spermatozoa were about 23.5µm in total length, and could be differentiated into three parts:an acrosome-less head, a short midpiece, and a typical long tail. The head is consisted of a nucleus and a plasma membrane, and bullet-shaped in about 1.8µm long and 0.8µm in diameter; an implantation fossa initiated from the bottom of the nucleus and implanted inward into a U-shaped nucleus; the proximal centriole and distal centriole (base body) inclined to each other and formed an angle of approximately 135º. The centriolar complex is consisted of the two centrioles and the initial portion of flagellum was located in the implantation fossa. The midpiece was a 0.5µm-long half-sleeve and contained a half-cylinder-shaped mitochondrion. The third part tail or flagellum was originated from the distal centriole, and the transverse section of the axoneme exhibited a typical "9+2" microtubules; the plasma membrane of the flagellum extended and formed two lateral fins. This study reveals that the ultrastructure of the spermatozoa of P. altivelis was very different from those of cyrpiniformes, and was unique among those of other fishes of the same-order Salmonidaes.
Key words:  Plecoglossus altivelis  spermatozoon  ultrastructure  Cypriniformes  Salmoniformes
版权所有 海洋与湖沼 Oceanologia et Limnlolgia Sinica Copyright©2008 All Rights Reserved
主管单位:中国科协技术协会 主办单位:中国海洋湖沼学会
地址:青岛市福山路32号  邮编:266071  电话:0532-82898753  E-mail:ols@qdio.ac.cn
技术支持:北京勤云科技发展有限公司