引用本文:

【打印本页】【下载PDF全文】【View/Add Comment】【Download reader】【 Close 】

过刊浏览高级检索

本文已被：浏览 1919次下载 2565次	码上扫一扫！
分享到：微信更多字体:加大+\|默认\|缩小-
一种适用于石油平台的有缆潜标系统的设计与布放方法
倪佐涛¹, 姜静波¹, 徐永平¹, 李思忍¹, 涂登志¹
中国科学院海洋研究所

摘要:

针对石油平台上的海洋环境动力检测, 设计一套有缆潜标系统, 并进行现场布放。该设计采用从海底到石油平台垂直布放一根受力钢缆, 测量设备和通讯电缆依附于受力钢缆上。布放时采用船舶布放有缆潜标水下部分, 平台布放有缆潜标水面以上部分, 两部分在水面附近进行连接, 调整受力。该设计可以大大降低布放成本, 避免有缆潜标系统缠绕平台桩腿等问题, 有一定的工程施工参考价值, 可以应用于石油平台的有缆潜标布放设计。

关键词: 石油平台有缆潜标布放

DOI：

分类号:

基金项目:中国科学院知识创新工程重要方向项目(KZCX2-YW-TS203); 国家海洋局公益性项目(201005027-6); 国家自然科学基金(41106084)

A design and deployment of mooring wired-buoy system for offshore jacket platform

Abstract:

This paper introduces a design and the deployment of mooring wired-buoy system for offshore jacket platforms. The system had a wire from sea bottom to platform, a cable and a sensor on the wire. The submerge wire deployed by vessel, connected submerge and over water parts at surface and platform elevation all parts at last. This approach improved the efficiency for the mooring procedure, and helped to avoid intertwined wires during the deploy process.

Key words: offshore jacket platform wired-buoy deployment

Copyright © Editorial Office for Marine Sciences Copyright©2008 All Rights Reserved
Supervised by: Chinese Academy of Sciences (CAS) Sponsored by: Institute of Oceanology, CAS
Address: 7 Nanhai Road, Qingdao, China. Postcode: 266071 Tel: 0532-82898755 E-mail: bjb@qdio.ac.cn
Technical support: Beijing E-Tiller Co.,Ltd.